PB 5252 - Horizontal Billet Saw

PB 5252 Horizontal Billet Saw


  • Heavy-Duty
  • Dual Post
  • Horizontal
  • Metal Cutting
  • 20 H.P.
  • 3” Blade

Get More Info


Download Brochure and Spec Sheets

Capacity
52" x 52", 52" Round. 22-1/2" Min. Clamp Width.
Blade
3" x 40' 4" x .063".
Blade Tension
Hydraulically controlled tension (40,000 psi) provides consistent square cutting accuracy. The Motion Detector will shut the machine off should a blade break or stall.
Speed Range
50-230 SFPM (15-70m/min.) infinitely variable through a frequency inverter system and a heavy duty Worm Gear Transmission. The broad speed range allows for optimum cutting of a large spectrum of materials. An Electric Tachometer assures accurate speed settings.
Hydraulic Down Feed
Feed rate and pressure can be controlled independently for fast, accurate cutting. Setup is made easy through the color-coded dial allowing the operator to select the best setting for the type of material being cut.
Hydraulic Shuttle Table
The 50” (1270 mm) x 85 1/2” (2175 mm) has five, 4” diameter rollers in front of the blade and four rollers behind that move the material to and from the saw. The entire table assembly rides on steel ways. The shuttle table work height is 27” and has a 23 1/2” stroke.
Motors
Blade Drive: 20 H.P., Hydraulic Pump Motor: 5 H.P., Coolant Pump Motor: 1/4 H.P.
Blade Guides
A combination of roller bearing and hydraulic actuated carbide blade guides assures the blade is held taut for fast, accurate cuts. The cast iron guide arms are positioned manually. The cast iron Movable Guide Arm is positioned through an Electric Motor, than is Hydraulically Locked in position.
Chip Brush
Powered from the main drive shaft of the saw, the brush changes speed along with the blade to assure that chips are being removed from each gullet of the blade, improving cutting performance.
Height Selector
To reduce the machine’s cycle time, the upward return of the saw frame can be limited through a variable height selector and can be set from 0-52”.
Stabilizer Bar
To reduce blade vibration upon entry into the work piece, a blade stabilizer bar is provided and aids in producing straighter cuts and helps to extend blade life by reducing blade vibration.
Cut Indicator Light
The cut line indicator light is positioned on the dovetail above the blade and casts a shadow indicating the true cut line which aids in set-up and assures first cut accuracy.
Vise Jaws
Two sets of vise jaws assure that even the largest piece of material will be held securely. The work piece is held on both sides of the blade, reducing cutting vibration which provides better blade life. Each vise can provide up to 5000 lbs. of clamping force.
Weight Capacity
The machine’s weight capacity is 40,000 lbs. allowing cutting of solids and billets to the machine’s maximum capacity.
Out-of-Square Detector
First Section 9’ Dead Roller Table
First Section 9’ Power Roller Table